High Torque Vane Motor – MV037 Series
R986V00451
MV037-A2-1S-026-30-B1-TBB-000
The MV037 series motors are hydraulically balanced internally
and therefore no significant radial loads are induced
on the motor bearings which contribute to long service life.
The motor can be configured with various bearing options
to accommodate external radial and axial loading. This data
sheet details standard motors (see Figure 1); technically
feasible, custom solutions may be offered. Please consult
factory.
Oil supply lines are connected to ports A and B on 2-port
and double stack motor configurations and to A1, A2, B1
and B2 on 4-port configurations. Case drain lines can be
installed on the C1 port. Reference motor unit drawings on
page 6 for additional case line locations and Case Drain
section on page 40 for details. Using the “A” port as the inlet will provide clockwise shaft rotation as seen from the
front of the shaft. Using the “B” port will provide counterclockwise
shaft rotation also seen from the front of the
shaft (see Figure 2 & Figure 3). The 4-port configuration
has the front housing port designated “A1,” the center
housing ports have been designated “A2” and “B1,” and the
rear housing port is designated as “B2.” This configuration
can be used as a two speed motor with appropriate external
valving. Like the motor with the single rotating group
when inlet flow is provided to the “A1 and A2” ports the
motor shaft rotation will be clockwise as seen from the
front of the shaft, and when inlet flow is provided to the
“B1 and B2” ports the motor shaft rotation will be counterclockwise
as seen from the front of the shaft (see Figure 4).
0 Comments